Destination-aware metric based social routing for mobile opportunistic networks

Wireless Networks - Although centrality is widely used to differentiate the importance of nodes for social-aware routing in mobile opportunistic networks (MONs), it is destination-agnostic since...     

超临界机组发生FAC的因素及相互关系分析

为了减轻因流动加速腐蚀(FAC)引起的锅炉结垢加速、汽水系统管道厚度减小甚至爆裂现象，对超临界机组发生流动加速腐蚀的机理及其主要影响因素进行了研究，并讨论了管壁内表面粗糙度、蒸汽含汽率、pH值、溶氧量对FAC的影响，以及温度与pH值、温度与流速、pH值与溶解氧量、溶解氧量与氢电导率等影响因素之间的相互作用关系，最后结合实际电厂的运行数据验证了分析结果。研究表明：减小工质流速、管壁粗糙度和氢电导率，增大给水的pH值和溶解氧含量可以使FAC的腐蚀速率减小，超临界加氧处理时pH值应在8.9～9.2之间，溶解氧量范围为45～100μg/L,氢电导率的期望值在0.1μS/cm以下。由于各影响因素之间的作用十分复杂，本文只给出了大致范围和趋势，并未给出准确数据。     

新型防屈曲高强钢腹板可更换钢连梁抗震性能研究

文章率先提出一种新型防屈曲高强钢腹板可更换钢连梁(简称“新型钢连梁”)：腹板采用高强钢，可提高钢连梁的屈服抗剪强度，连梁变形减小，从而减小可更换结构整体变形，便于更换；加劲肋紧贴腹板(但不焊接)提供约束，仅与上下翼缘焊接，可减少60%以上的焊接量。其次，设计并开展了11个试件的拟静力试验，研究了加劲肋间距(规范限值dmax、0.85dmax)、腹板厚度(6mm、8mm)、腹板钢材强度(Q460、Q550)和构造形式(加劲肋与腹板贴紧或焊接)等参数对新型钢连梁抗震性能的影响。试验结果表明：试件均发生剪切破坏；满足加劲肋间距限值的新型钢连梁，滞回曲线饱满，峰值时腹板未发生鼓曲且极限转角均超过0.1rad，大于规范限值0.08rad，表现出良好的耗能和变形能力；缩小加劲肋间距、增加腹板厚度或提高腹板钢材强度，新型钢连梁刚度及承载力提高；新型钢连梁峰值承载力较传统构造试件低约5%。最后，基于试验结果建立了有限元模型并开展了分析，研究结果表明：对腹板采用Q460、Q550高强钢材的新型钢连梁，峰值承载力计算时超强系数建议取1.43(长度比为0.5～1.0)或1.39(长度比为1.0～1.6)、1.25，以期为实际工程设计提供依据。     

Co?N graphene encapsulated cobalt catalyst for H2O2 decomposition under acidic conditions

Hydrogen peroxide (H₂O₂) has been listed as one of the 100 most important chemicals in the world. However, huge amount of residual H₂O₂ is hard to timely decomposed into O₂ and H₂O under acidic condition, easily resulting in explosion hazard. Here, we reported a core–shell structure catalyst, that is graphene with Co N structure encapsulated Co nanoparticles. Co N graphene shell serves as the active site for the H₂O₂ decomposition, and Co core further enhance this decomposition. Benefiting from it, the H₂O₂ decomposition were close to 100% after 6 cycles without pH adjustment, which increased 6 orders of magnitude compared with no catalyst. At the same time, the O₂ generation reached 99.67% in 2 h with little metal leaching, and ·OH has been greatly inhibited to only 0.08%. This work can cleanly remove H₂O₂ with little deep oxidation and protect the process of H₂O₂ utilization to achieve a safer world.     

Study on the removal of olefins from naphtha by clay loaded with trifluoromethanesulfonic acid

Journal of Porous Materials - In this work, a trifluoromethanesulfonic acid (TFOH) modified clay (TFOH-Clay) was developed for the removal of trace olefins in heavy naphtha. 5%TFOH-Clay can...